pulsarlube m, automatic lubricator

Pulsarlube M - Electro Mechanical Unit, Automatic lubricator

Overview

The Pulsarlube M automatic lubricator has been developed to compensate the perfromance of the gas-type automatic grease lubricator, which has been used widely. This product has combined the vertical self-priming pump mechanism and microprocessor control system, and it can be used mainly in case of considerable back pressure from the bearings, when precise lubrication is needed, and when a disposable lubricator is not economical.

Operating principle

This automatic lubricator product has a mechanical lubricant dispensing system with the motor/gear set controlled by the microprocessor and vertical self-priming pump. The dispensing rate may be set by choosing from 6 modes ― 1 month, 2 months, 3 months, 6 months, 12 months, and 15 days ― according to the characteristics of the equipment.

Built-in Large LCD & High Operating Pressure

The built-in large LCD screen is easy to use, helping one detect the malfunction. This is a semi-permanent, mechanical automatic grease lubricator that is more economical than the formal single-use products since it enables replacing the grease pouch and battery pack after use.

With high operating pressure of 30kgf/㎠, this product has increased dispensing reliability and installation in case gas-type products cannot be installed because of the high back pressure, allowing remote installation and multi-point lubrication.

How to order

KLT125① / PL1 (125cc)②

KLT250① / PL1 (250cc)②

① Product code

② Grease type

lubricant dispensing system

Electro Mechanical Unit M

View  Gallery:

Back to top

Pulsarlube M Benefits, Automatic lubricator

Electro Mechanical Unit

Multi point installation of Pulsarlube M / The built-in large LCD screen.

Benefits

  • Programming is extremely user friendly with the press of a single button.

  • An easy to read LCD screen provides all the necessary information for set up and status of your lubricator and lubrication point.

  • “Go Green” Pulsarlube M is reusable!

  • The Automatic lubricator Pulsarlube M has an excessive backpressure sensing capability mode allowing you to trouble shoot this type of condition. This will assist in avoiding the possible catastrophic failure of your rotating equipment.

  • Test function performs an all points system check on the microprocessor such as dispensing rate, output pressure, LCD display, etc.

  • High output pressure (30kg/cm2 (430 psi)) allows for remote installation up to 8 points, max 6 meters (20 ft) per point. This permits you to conveniently lubricate hazardous and hard to reach areas.

  • Easy to read low battery icon indicator. Pulsarlube M Grease

  • The M series lubricator contains a unique automatic “Lockout system” to prevent any possible accidental/unauthorized re-programming of the unit after it has been set.

    • Pulsarlube products